DC-DC Feedback Resistor Selection
From Vref and target output voltage, enumerate the best divider across E3–E192 series and report actual error.
Key points
DC-DC Feedback Resistor Selection: From Vref and target output voltage, enumerate the best divider across E3–E192 series and report actual error. Formula: Vout = Vref × (1 + R1/R2). Enter parameters on the DD-CAT IDE online tool page to get results instantly, with a calculation-model diagram that updates with the inputs. Smaller R2 raises divider current and noise immunity but also static loss; for Buck light-load efficiency, choose hundreds of kΩ. Keep the feedback trace short and away from switching nodes / inductors; add the FB filter capacitor per the chip datasheet.
Inputs
Vout = Vref × (1 + R1/R2)Calculation model (updates with parameters)
| recommended R1 (top) / R2 (bottom) | 357 kΩ / 115 kΩ | actual output 3.283 V |
| alternative 1 | 35.7 kΩ / 11.5 kΩ | Vout 3.283 V | error 0.50% |
| alternative 2 | 3.57 kΩ / 1.15 kΩ | Vout 3.283 V | error 0.50% |
| alternative 3 | 107 kΩ / 34 kΩ | Vout 3.318 V | error 0.53% |
| alternative 4 | 10.7 kΩ / 3.4 kΩ | Vout 3.318 V | error 0.53% |
| alternative 5 | 332 kΩ / 107 kΩ | Vout 3.282 V | error 0.54% |
| recommended divider current | 6.992 µA | 50µA–1mA typical, balancing power and noise immunity |
| recommended combination error | 0.50% |
Engineering notes
- Smaller R2 raises divider current and noise immunity but also static loss; for Buck light-load efficiency, choose hundreds of kΩ.
- Keep the feedback trace short and away from switching nodes / inductors; add the FB filter capacitor per the chip datasheet.
FAQ
- What is DC-DC Feedback Resistor Selection for?
- From Vref and target output voltage, enumerate the best divider across E3–E192 series and report actual error.
- What is the formula for DC-DC Feedback Resistor Selection?
- Core formula: Vout = Vref × (1 + R1/R2). The tool returns results instantly using this formula and the selected parameters.
- What engineering notes should I keep in mind when using DC-DC Feedback Resistor Selection?
- Smaller R2 raises divider current and noise immunity but also static loss; for Buck light-load efficiency, choose hundreds of kΩ. Keep the feedback trace short and away from switching nodes / inductors; add the FB filter capacitor per the chip datasheet.
Embed this calculator on your site / blog / intranet
Copy the snippet below into any HTML-capable page — visitors get the same live calculator, styling included.