Junction Temperature Calculation Sparked by a "Hot Case"
Last year I was debugging a 12V-to-3.3V LDO board mounted in a sealed plastic enclosure. The chip package felt noticeably hot to the touch, and the board occasionally reset. A multimeter measured 12V in, 3.3V out, and about 500mA of current, giving power dissipation P=(12−3.3)×0.5=4.35W. The datasheet listed Tj(max)=125°C; at the time I thought it was "not exceeded." Later an IR thermometer measured the case at over 90°C, and I realized judging junction temperature by feel alone is completely unreliable.
The Thermal Resistance Chain and Three Formulas
Chip heat follows the "junction → case → heatsink → ambient" thermal resistance chain:
Here P is the chip's own power dissipation, not output power; for linear regulators use , and for DC-DC derive losses from efficiency. Among the three resistances, comes from the datasheet, depends on the interface material (thermal grease about 0.1~0.5°C/W, silicone pad about 0.5~1.5°C/W, dry contact is much larger), and depends on the heatsink spec or PCB copper area. The ambient temperature must reflect the real system: for a sealed enclosure I generally use 45~55°C, not 25°C.
Running the Parameters Through the Calculator
I later entered the data into the Chip Heating / Junction Temperature Calculator: P=4.35W, T_A=50°C, θ_JC=15°C/W (SOT-223 package), θ_CS=0.5°C/W (grease + mica sheet), no heatsink, natural convection θ_SA≈28°C/W. The calculator returned:
- Total thermal resistance θ_JA = 15+0.5+28 = 43.5°C/W
- Junction temperature T_J = 50+4.35×43.5 ≈ 239°C
- Case temperature T_C = 239−4.35×15 ≈ 174°C
- Margin = 125−239 = −114°C, meaning Tj is nearly double the 125°C limit
This result immediately explained why the case was hot and the board reset. With a 3°C/W heatsink, θ_JA=18.5°C/W and T_J≈130.5°C, still right at the 125°C limit; switching to DC-DC cut dissipation to about 0.6W and T_J≈61°C, finally providing real margin. The calculator's "no heatsink / with heatsink" comparison view was very helpful for selection.
Selection Conclusions and Common Mistakes
My habit now is: first compute P at maximum input voltage and maximum continuous current, then compute T_J at the highest in-enclosure ambient temperature, keeping at least 20~30°C of margin; sustained junction temperatures above 85°C significantly shorten lifetime. Common mistakes I list below:
- Using "output power" as dissipation in the formula;
- Copying 25°C for ambient temperature and ignoring the temperature rise in a sealed enclosure;
- Directly using the datasheet θ_JA, which reflects JEDEC standard PCB conditions and differs greatly from your board's copper area and layer count;
- Forgetting θ_CS and assuming attaching the chip to a heatsink is enough;
- Checking only junction temperature without verifying case and heatsink temperatures, letting surrounding components overheat.
Related Tools
After the junction temperature calculation, if you need to handle power ripple, try the RC Low-Pass Filter Calculator to suppress high-frequency noise and switching spikes on the power output; I also revisit current and voltage-drop parameters for power-related work to avoid iterative design.