Skip to main content
DD-CAT IDE logoDD-CAT IDE

Tutorials

Algorithm graph: building a digital power loop

FavoriteAdvanced~25 minAlgorithm graphDigital powerGS32

Key steps

  1. 1.In the algorithm graph editor, drag in 3 "variable read" blocks (VIN/VOUT/IOUT) and the buck_boost_cvcc block
  2. 2.Connect by port dtype (f32 same-type direct); wire EN/VSET to enable and setpoint
  3. 3.Set target output voltage / current limit / compensation parameters (fixed-point raw) in the property panel
  4. 4.The DUTY output drives the power stage via "variable write"; wire IERR/FALT to the alarm UI
  5. 5.After passing the export validation gate, flash the GS32 board and verify the duty waveform on a scope